Riello PWP 800 UPS in Bypass mode

[DavidMcMahon]

Hello I have been looking at and considering a Riello PWP 800 UPS

http://static.riello-ups.co.uk/riello/pdf/ab/ab_etm.pdf

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=120599098105&ssPageName=STRK:MEWAX:IT

I have at the vendor's connected the device in single phase operation, the UPS powers up and the controls seem to be working, no warning lights etc

Now.. The problem is that the UPS is in "Remote By-Pass mode" which means it is not working as a UPS, I tried to find the correct option in the menu to switch it to "normal" operation, alas I fail!

I see on that .pdf that on page 24 there is a 15 pin D-sub connector to control the :-

Remote on (Pins 2 - 15(Gnd) for >3 seconds.

Remote off (Pins 2 - 15(Gnd) (same pins as Power on)

Remote by-pass (Pins 7 - 15(Gnd) (Maybe the problem lies here?)

The other pins are for output use!

SO I have not got anything connected to the 15-pin D-Sub, yet the device is in Remote By-Pass mode.

Does anyone have one of these beasts (30 Batteries!) and can shed any light?

Right I think that's enough of a first post now!

If you are ever in Suffolk, knock me up for a beer!

Hello, Im David McMahon

IT Support in Suffolk, UK

 

[DavidMcMahon]

Does anyone know about these?

Thanks, David

Hello, Im David McMahon

IT Support in Suffolk, UK