Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

restricting inbound in CCM from a caller ID

Status
Not open for further replies.
noidatech

noidatech

Technical User
May 15, 2006
99
US
i wanted to restrict calls from a specific caller ID into call manager, will route pattern or translation help

anybody has a good document to start
 
Sort by date Sort by votes
just wanted to mention that i am using MGCP gateways...and so i am just trying to find a way to restrict them in call manager or on gateways
 
Upvote 0 Downvote
I have only seen this when H.323 was used...

I am not sure that MGCP will help you in this case...


[americanflag] SPC NVARNG
Tek-TIP Member 19,650
 
Upvote 0 Downvote
Since the 'D' channel is backhauled to the CCM there is nothing you can do in an MGCP gateway. I don't know of any way to stop a call based on CLID in CallManager.
 
Upvote 0 Downvote
If this is a business requirement you will have to change your gateway from MGCP to h323 controlled protocol.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Gnjiro
  • Locked
  • Question
Cisco Ip Phone 7841, 7821 Delay when making call both inbound and outbound in sip protocol
Replies
3
Views
269
thepfy
thepfy
keyset6
  • Locked
  • Question
Access line in use from Jabber
Replies
2
Views
167
keyset6
keyset6
keyset6
  • Locked
  • Question
No transmit from new laptop microphone using Jabber
Replies
7
Views
443
keyset6
keyset6
keyset6
  • Locked
  • Question
Cisco Unity delay after Caller Input selection with Call Handler
Replies
1
Views
197
keyset6
keyset6
Russell35674
  • Locked
  • Question
Cisco VG310/320 migrate from SCCP to MGCP
Replies
1
Views
232
whykap
whykap

Part and Inventory Search

Sponsor

Back
Top