Facts:
- Netwokrer Server 7.4.3 Red Hat Linux x86
Client
- Microsoft Windows 2008 Server SP1 (32bit)
- Networkert Client 7.4.3
Discription:
We backup the Microsoft Windows 2008 with the save set All and without any errors.
If we make a complete restore over the existing Windows 2008 the server will reboot after the restore normally.
If i make a new installation of Windwos 2008 and then make a full recover with the same backup as before the server didn't reboot. It hangs before the login screen appears and automaticly restart againg.
Steps:
- I install a new Windows 2008 SP1
- Set the same IP Address and the computername as before
- install Networker client 7.4.3, connect to the Networker Server and restore
- The restore is sucessful without any error messsages
- After the Reboot the server can not start again. It hangs and make a loop.
Any Idee what the problem is?
Thanks for your help
- Netwokrer Server 7.4.3 Red Hat Linux x86
Client
- Microsoft Windows 2008 Server SP1 (32bit)
- Networkert Client 7.4.3
Discription:
We backup the Microsoft Windows 2008 with the save set All and without any errors.
If we make a complete restore over the existing Windows 2008 the server will reboot after the restore normally.
If i make a new installation of Windwos 2008 and then make a full recover with the same backup as before the server didn't reboot. It hangs before the login screen appears and automaticly restart againg.
Steps:
- I install a new Windows 2008 SP1
- Set the same IP Address and the computername as before
- install Networker client 7.4.3, connect to the Networker Server and restore
- The restore is sucessful without any error messsages
- After the Reboot the server can not start again. It hangs and make a loop.
Any Idee what the problem is?
Thanks for your help