Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Reset IP phones system wide

Status
Not open for further replies.

Stacyjo5

Technical User
May 17, 2004
149
US
I have a CS1000E with Geographic redundancy (not working yet - just noting because of my annoyance) with about 350 sets deployed around town at about 19 MGs - I am making some changes to the DHCP scope and would like to reset all the sets remotely so they will acquire the new DHCP info - any help on how I can do this through the system without visiting each set?

Thanks in advance!
 
You can use the following command in LD 117:

RST ZONE - Reset Ethersets in specified zone
 
If that doesn't work and the phones are powered via POE, you can turn off power to each port on the switches. A little more work but do able.
 
Log into the SigServer and type:

isetReset all

If you have more than one sigserver, you will need to log into all followers and do the same.
 
Thanks everyone - the sets are spread out over multiple schools throughout the county, so unplugging every switch would be super time consuming, but I will try the other options!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top