Reset Controller for Remote Shelf 4

[jtphoneman]

We have an 81C succ 3.0 Superloop 24 is out. It runs a remote shelf.
Super Loop 24
xpec 08
What are the commands to disable both and reset the controller card in the PBX? Do I need to reset the card in the remote shelp too?

I get the following message:
XMI000 24 : RSIG link lost on Port #0 - Reinitialized

Thanks.

 

[TAnselm]

I should probably add on to my RANT...

The idea here is to test the T1 from end to end. The carrier is notorious for only testing in the middle.

You need to ensure that you have a complete circuit from where the cable plug into the local to the where the cable plugs into the remote.

Granted it may just as likely be your cabling as opposed to your carrier's. But at least you have control over your side from the smart jack to the equipment.

 

[jtphoneman]

Telco is back onsite this moring. They are going to run a teset from the remote site to a loop plug here at teh 81c. I hope this will verify the T1 is working. As far as the xpe when I prt xpe in 97 it shows xpe for loop SL 24 is 08. We do have Kentox ACD on both ends.

 

[jtphoneman]

>ld 97
SCSYS000
MEM AVAIL: (U/P): 6884540 USED U P: 4748799 146753 TOT: 11780092
DISK SPACE NEEDED: 192 KBYTES
2MB BACKUP DISKETTE(S) NEEDED: 1 (PROJECTED LD43 - BKO)
REQ prt
TYPE xpe
XPEC

S0 S1 S2 S3 LOC DIS RGTP

01 004 004 004 004 NO 08
02 004 004 004 004 IMCREM NO 16
03 020 020 020 020 NO 08
08 024 024 024 024 IMCREM YES 16

>ld 32
NPR000
.enll 24
TEST PASSED
XPE0 CONNECTED
XPE1 NOT CONNECTED
LCRI HAS RECEIVED ENABLE MSG
PROCESSING TN....
OK
.
XMI000 24 : RSIG link lost on Port #0 - Reinitialized
enxp 08

XMI000 24 : RSIG link lost on Port #0 - Reinitialized

XMI000 24 : RSIG link lost on Port #0 - Reinitialized

NPR327
.

 

[jtphoneman]

Problem solved, Telco had to swap positons on the channel bank. ( so it was a T1 issue)All of your guys sure helped, thanks

 

[TAnselm]

TADA....

 

[strmwalker]

jtphoneman..glad we could help,and glad you are backup
and running.

no problems only solutions

strmwalker