I will need to replace a roll printer (RS232 interface). The replacement is the same model. The workstation is running Windows CE (type 5A). Workstaion's IP doesn't change.
First time adding a printer, any manual? What is the procedure? Thanks!
Look under the printer you will see a small metal cover remove it and inside you will see some dip switches. Set the switches the same way as the old printer and attach it to the workstation.
The damaged printer has been disposed, cannot find it so cannot compare. Connected the replaced printer to the workstation, the printer didn't work. Print job was redirected to the backup printer. Re-calibrated the workstation, didn't work either.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.