Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Reports using "&" in the report Header

Status
Not open for further replies.
pbrown2

pbrown2

Technical User
Jun 23, 2003
322
0
0
US
I need to use & in the report header. i.e. FY03 & FY04. However, the "&" will not appear on the print-out. Please, any ideas are welcomed.
 
Sort by date Sort by votes
If you enter the & twice it normally appears as one on the display.

Regards
Dave
 
Upvote 0 Downvote
Delimit it by putting an additional '&' in. To do it in code, use the Replace function.
e.g. set the control source to
= Replace([MyReportHeaderField],"&","&&")
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Zandy12
  • Locked
  • Question
Repeat the Report Header after Page Header / Details ends.
Replies
1
Views
175
dhookom
dhookom
VicM
  • Locked
  • Question
Curious behavior using Chr(10) & Chr(13)
Replies
4
Views
153
SoftwareRT
SoftwareRT
Teri Bridges
  • Locked
  • Question
Reports Combobox-List box
Replies
1
Views
80
dhookom
dhookom
JimStrand
  • Locked
  • Question
Expression Limit on Sum IIf In Method ? Used in Report Calculation
Replies
1
Views
104
dhookom
dhookom
SamuelR
  • Locked
  • Question
Dlookup in a report
Replies
13
Views
129
dhookom
dhookom

Part and Inventory Search

Sponsor

Back
Top