Report Margin Problem - Extra Blank Page

[davesaint]

What are the maximum magin settings that can be used to setup a report in the landscape mode? I set my margins at .25". Each one of my reports now have an extra page that is blank at the end. I'm looking for a solution that will fix this issue.

 

[mdthornton]

Do have just one blank page or a blank page for each page of your report? Ie if report is 4 pages you get 8 in total printed with 4 blanks.

If you only get one extra page its unlikely to be margin related - have a look at the properties for the report footer section. Make sure it is set to "none".
Best Regards,
Mike

 

[WildHare]

Is this the "ghost" page problem - where a control has somehow "widend" your logical page with to greater than 10.5" (11 physical - .5 margin) - you'd get the message about "logical page width greater than physical" or some such thing ??? Check to make sure your logical width (the area of the 'design grid' is not wider than your physical page.

"Remember, you're unique - just like everyone else"
You're invited to visit another free Access forum:

http://www.forumco.com/jmhare

or my site,

http://www.jmhare.com

 

[Mksmall]

I had the same problem with a report that I had made and the only way I could repair it was to copy and paste the report and delete the original. Hope it works for you.