Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Replacing tapedrive Autochanger/Networker

Status
Not open for further replies.

papad

Technical User
Oct 3, 2003
9
NL
Hello,

I have an autochanger (4560SLX 0429|Autochanger (Jukebox), \\.\Changer0) with 2 tapedrives. Till now I had one LTO1 and one LTO2 dirve. I just replaced the LTO1-drive with an LTO2-drive.
The drive is visible in window and with inquire, but in the gui of Networker stays as LTO1. How I can change that?

Additional: since I placed the new tapedrive I can't mount any tape (not in the old LTO2 drive too), and I get with inventory that the tape is unlabeled.

Any suggestions?

Thanks in advance!

papad
 
Note the jukebox name, then delete it and the tape drives
from within NetWorker. The just run a new jbconfig and give the jukebox the same name as it had before. Afterwards, just run a new inventory (nsrjb -Iv) and you should be all set.

Cheers!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top