Replacing tapedrive Autochanger/Networker

[papad]

Hello,

I have an autochanger (4560SLX 0429|Autochanger (Jukebox), \\.\Changer0) with 2 tapedrives. Till now I had one LTO1 and one LTO2 dirve. I just replaced the LTO1-drive with an LTO2-drive.
The drive is visible in window and with inquire, but in the gui of Networker stays as LTO1. How I can change that?

Additional: since I placed the new tapedrive I can't mount any tape (not in the old LTO2 drive too), and I get with inventory that the tape is unlabeled.

Any suggestions?

Thanks in advance!

papad

 

[NWNinja]

Note the jukebox name, then delete it and the tape drives
from within NetWorker. The just run a new jbconfig and give the jukebox the same name as it had before. Afterwards, just run a new inventory (nsrjb -Iv) and you should be all set.

Cheers!

 

[Chapter11]

+1 to NWNinja. That's the best way of doing it.