Replacing a Standby IPSI and configuring it

[S8700Girl]

I just swapped out a Standby IPSI board and realized that I have to telnet into it to configure it. I know I need a crossover cable. But I was wondering if I can use Putty to telnet into it if I put in the correct ethernet port of 192.11.13.15 and 255.255.255.252?

 

[Hudson22]

Yes putty, but check your IP address. Should end in .5 not .15.
192.11.13.5
Hudson22

 

[fataldata]

Yes PuTTy can telnet. It will set the port of 23 automatically but the ip you have is not correct. Check the FAQ page

IPSI TN2312 Firmware Upgrade Instructions

 

[Hudson22]

Just to clarify the .5 would be your laptops address and then go to 192.11.13.6 for the IPSI.
Hudson22

 

[S8700Girl]

So when I put an entry in putty to go to the IPSI board port, I want to put in 192.11.13.6, correct? Then I can follow the procedure to add or check settings, etc.?

 

[Hudson22]

Yup....ping it first to verify connectivity.

 

[Hudson22]

Plug crossover cable into port labeled services on IPSI board.

 

[S8700Girl]

So I cannot just use Putty from my laptop without configuring the laptop with the ip address 192.11.13.5. Putty will have an entry to the IPSI of 192.11.13.6. I am planning on doing this later this week. Thanks.

 

[montyzummer]

Correct on your last post ,also ensure the gate way on your nic settings form your laptop is the ip of IPSI services port 192.11.13.6.


Laptop Settings
ip address. 192.11.13.5
subnet. 255.25.255.252
def gw. 192.11.13.6

APSS (SME)
ACSS (SME)
ACIS (UC)

 

[montyzummer]

subnet 255.255.255.252 typo apologies

APSS (SME)
ACSS (SME)
ACIS (UC)

 

[S8700Girl]

I cannot recall how to change the ip address on the laptop. Can someone give me the steps to do this? Sorry, I do not remember. Thanks.

 

[smokinjoe2938]

depends on the operating system version

acss sme acis sme acss cm 5.2.1 acss cm and cmm acss aura messaging.

 

[S8700Girl]

windows 7 32 bit

 

[smokinjoe2938]

go to network/network and sharing/change adapter settings/go to your local area connection/properties/tcp/ipv4 and hit properties again, from there you should be able to change it.

acss sme acis sme acss cm 5.2.1 acss cm and cmm acss aura messaging.

 

[DavidJ1013]

You can also set the IPSI to receive the IP address automatically follow this link and and on PAGE 53 it will explain how...sorry easier than writing it out and don't worry its an Avaya doc

http://downloads.avaya.com/css/P8/documents/100015876