removing lines from line pool and moving lines around on phonekeys

[biilici]

Hello

I need to remove some lines from the outdialing pool group.
These lines were removed from the phone system.

Now on occassion if you try to make a call using the out calling you get dead air where these lines were before.

I also would like to know how to move a line that is on one key to another key on the phone.

At the receptionist desk, where all lines appear on all keys, she now has two posistions that are now blank. I would like to move the lines around on the keys that are now blank for continuity's sake

Thanks

Bill

 

[lugerlover]

change in line programming from line pool * to public

feature *81 moves line to another button location

 

[biilici]

Hello

could you be a little more specific in the sequence used to program the line out od the line pool

and alos what i put in after

feature *81

for example if I wanted to move line 002
to a line button on a squared phone

Bill

 

[lugerlover]

nope...if you dont know the basics call a vendor and have them train you...will be money well spent

 

[biilici]

Thanks for your help.

My software level is SP30JBMO7 NAT

The information I was given for removing lines from a pool
was for a newer version.
i would appreciate how to do it on my version of software

 

[phoneguy427]

You have a MICS 1.1, can't remember if it is configuration or terminals and sets. let me know, and then I can tell you where to look.

 

[biilici]

it is configuration

 

[champ203]

go into config under trk/line data type in line # and it is under line data- line type change from pool to public

 

[lugerlover]

Trunk Type Loop
Line type Pool A **** <------ change this----->*****
Dial mode Tone
PrimeSet 221
CLID Set (analog only) None
Auto privacy Y
Trunk mode Unspr
Ans mode Manual
Ans with DISA Y
Link at CO (analog only) N
Aux. ringer N
Full AutoHold N
LossPkg MediumCO

or pay me to do it

 

[biilici]

that was it
thanks a lot

Bill