Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Removing a T-1

Status
Not open for further replies.

tnjwinters

Programmer
Jun 15, 2005
390
US
I am tearing down a T-1 off one of my 1010 PRI Gateway cabinets. Right now the site has two T-1's and I only need one. I want to make sure I don't miss anything. Can someone give me the set by step.

Thank you,
 
Are both the T-1 trunks in the same route?

Basically you have to remove the trunks in LD 14
If in a route by themselves then remove the route in LD 16, otherwise if they share a route leave it alone
Remove the d-channel in LD 17 if it has one
Remove the DLOP in LD 17

You will have to disable everything first.

If your clocking is on the loop you are removing you will need to change it to the other loop
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top