Removed subinterface, but still shows in "show interface" 2

[slyride]

Hello,
I recently moved our Frame network to a MPLS.
I had a bunch of sub interfaces that were no longer in use so I deleted them using the no interface hssi0/0.x command, however they still show up when I use the show interface command. Is there a way to remove all traces of them?
Thanks
Leon

 

[jneiberger]

You can only remove those remnants by rebooting the router. Interestingly, I had the same problem when we moved from frame relay to MPLS.

 

[slyride]

Ahhh, Have not done that yet, will give it a try tonight. It had just thrown off one of my co-workers because we had a line down and they had always been instructed to check the sh int on the hub router.
Thanks
Leon