Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Remote Office 9115
- Thread starter josele
- Start date
Firstly you need a Reach Line card as well. It makes it a lot esier to get off the ground if you have the GUI. On there select the Configuration Wizard and follow the steps.
Decide on 2 IP addresses, 1 each. Then connect to the RLC via serial the first time, Assign IP, Subnet, Default gateway etc.
Do the same on the 91xx and reboot.
On the PBX just build the digital extensions as normal. This will get you basic connectivity. After that just go and play.
Hope that this helps. If not drop me your email and I will get back offline..
Jason
Decide on 2 IP addresses, 1 each. Then connect to the RLC via serial the first time, Assign IP, Subnet, Default gateway etc.
Do the same on the 91xx and reboot.
On the PBX just build the digital extensions as normal. This will get you basic connectivity. After that just go and play.
Hope that this helps. If not drop me your email and I will get back offline..
Jason
- Thread starter
- #3
- Thread starter
- #5
- Status
Similar threads
