remote cabinet

[ke123]

I had an issue this morning. Another site reported phones went down but then back up. This is what is showing on the switch...What could have caused the issue? Where do I check to make sure we're ok (LD32/60?)?

XMI001 52 0 6 XDLC

XMI001 52 0 7 XDLC

XMI001 52 0 8 EXUT

XMI002 52 0 6 XDLC

XMI001 52 0 7 XDLC

XMI002 52 0 7 XDLC

XMI002 52 0 8 EXUT

XMI002 52 0 9 EXUT



DTC001

 

[pbxn]

I'd look at the history to see what happened. ld 22 prt, vhst/ahst either one. Chances are that site maybe lost power, just a guess.

 

[johnpoole]

no that loop does not show up in 60.. in ld 97 prt xpe return, find the xpe of 52 0 then idcs x.. that will show the cards on the far end.. that can be caused by a drop in the t1 or a power glitch on the far end... all the errors show is that it went down and came back up..

i assume this it a carrier remote.. those t's are not in 60 but you can plug into the mmi interface and look at them for errors if this happens more then once

john poole
bellsouth business
columbia,sc

 

[TAnselm]

I would guess a mini-carrier remote... it's reporting individual cards, not loops. Probably a power outage would be my guess.

 

[ke123]

The remote site said power was fine....only phones went out....thanks I will check history and ld 97

 

[ke123]

one more thing....I keep on getting this message

XMI000 28 : Msg from FPEC error #0001

what does that mean?

 

[bigindian65]

. MSG FROM SHELF x: XPEC ERROR 0001. This error is
usually self correcting. If may indicate a double timeslot problem or
invalid call teardown.

You know once logged in you can look up ERR. BUG, SCH? Do ERR (space)and the message for all types.

> err XMI000 <enter>

 

[johnpoole]

i get each card when my carrier remote goes down.. in my 81 you can not determine if it's a ,mini or a carrier remote..

is your remote on a ups?

john poole
bellsouth business
columbia,sc

 

[ke123]

Good question....I asked site contact and he does not know except that cards went red then green asked if UPS was conectecd and no idea.....I will doublecheck

 

[ke123]

johnpoole - what commands in LD97? 'ld 97 prt xpe return, find the xpe of 52 0 then idcs x'