Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Remote BCM 50 needs to use PRI on BCM 450

Status
Not open for further replies.

SRC1

Programmer
Oct 4, 2009
65
US
Guys I have a 3 BCM50s using analog lines for out dial networked with a BCM 450 with a PRI. Need to have 50s use PRI on the 450 for out dialing. BCMs use customer network with H323 trunking over IP trunks and dest codes. Can't seem to get a routing solution have tried a few with no luck. Any suggestions? Thanks in advance. Steve
 
Did you build Remote Access Package? You need to tell the inbound (trunks from the 50's) route to the 450 that it is ok to use the Outbound (PRI)
 
Thanks so to access PRI from 50s what dest code would work?
 
It's been awhile...but I believe you build a public network on the 50 pointing to the 450. You would be dialing 9+NXX-XXXX that would be sent across the H.323 pipe to the 450. You create remote package on the 450 looking for the 9+ numbers coming from the 50 and you would tell the remote package what route (or PRI pool) to use...that's the gist of it.

Jim

"If I had known it would turn out like this, I would have become a locksmith" Albert Einstein

NCSS, NCTS, NCTE, CS1000E, Avaya IP Office, Mitel 3300 Basic & Advanced, 5000, SX200, NuPoint
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top