Remote BCM 50 needs to use PRI on BCM 450

[SRC1]

Guys I have a 3 BCM50s using analog lines for out dial networked with a BCM 450 with a PRI. Need to have 50s use PRI on the 450 for out dialing. BCMs use customer network with H323 trunking over IP trunks and dest codes. Can't seem to get a routing solution have tried a few with no luck. Any suggestions? Thanks in advance. Steve

 

[hawks]

Did you build Remote Access Package? You need to tell the inbound (trunks from the 50's) route to the 450 that it is ok to use the Outbound (PRI)

 

[SRC1]

Thanks so to access PRI from 50s what dest code would work?

 

[hawks]

this thread should help

http://www.tek-tips.com/viewthread.cfm?qid=1437260

 

[Crowtalks]

It's been awhile...but I believe you build a public network on the 50 pointing to the 450. You would be dialing 9+NXX-XXXX that would be sent across the H.323 pipe to the 450. You create remote package on the 450 looking for the 9+ numbers coming from the 50 and you would tell the remote package what route (or PRI pool) to use...that's the gist of it.

Jim

"If I had known it would turn out like this, I would have become a locksmith" Albert Einstein

NCSS, NCTS, NCTE, CS1000E, Avaya IP Office, Mitel 3300 Basic & Advanced, 5000, SX200, NuPoint