PLEASE HELP – Thank you very very much!
At Core Site:
I have two Cisco 7206s each with one DS3 to the frame cloud
Each 7206 is connected to each other through two Cisco 5509 switches via Fast Ethernet
At Remote Site:
Cisco 2610 with two PVCs (one PVC to each of the 7206)
PVC 1 = 64k with 16kcir (DLCI 20 mapped to DLCI 16)
PVC 2 = 64k with 8kcir (DLCI 20 mapped to DLCI 17)
Drawing:
Remote Site (DLCI 20)
----------16kCir---|----8kCir-----------
| |
--------------FRAME CLOUD----------------
| DS3 | DS3
7206 #1 (DLCI 16) 7206#2 (DLCI 17)
| |
5509-------------100Mbit-------------5509
Question:
I am looking at the best way to provide redundancy with these dual DS3.
I am looking into EIGRP however with the CIRs not the same I am not sure this is a good solution.
Any suggests would be a helpful. I am not looking for some to engineer this project for me, I am asking the forum because I am look for advice on what my steps should be. Thank you very much again
At Core Site:
I have two Cisco 7206s each with one DS3 to the frame cloud
Each 7206 is connected to each other through two Cisco 5509 switches via Fast Ethernet
At Remote Site:
Cisco 2610 with two PVCs (one PVC to each of the 7206)
PVC 1 = 64k with 16kcir (DLCI 20 mapped to DLCI 16)
PVC 2 = 64k with 8kcir (DLCI 20 mapped to DLCI 17)
Drawing:
Remote Site (DLCI 20)
----------16kCir---|----8kCir-----------
| |
--------------FRAME CLOUD----------------
| DS3 | DS3
7206 #1 (DLCI 16) 7206#2 (DLCI 17)
| |
5509-------------100Mbit-------------5509
Question:
I am looking at the best way to provide redundancy with these dual DS3.
I am looking into EIGRP however with the CIRs not the same I am not sure this is a good solution.
Any suggests would be a helpful. I am not looking for some to engineer this project for me, I am asking the forum because I am look for advice on what my steps should be. Thank you very much again