Redirect Extension(no answer) to Idle access Line

[Ramon Zaragoza]

Hi i want to Redirect Extension(no answer) to Idle access Line, to make and outside call.

 

[WhiteGooner]

I'd be interested to know you would want to do this???

 

[Ramon Zaragoza]

Hi, thanks for the answer

I have 3 ns500's, all connected using the IP-GW.

How can I place a call from one PBX to another PBX using the TIE IP-GW connection but route the call outwards?

For example - if I could place call from PBX 1 to PBX 2 and then use PBX 2 to get to the outside world, it would save on long distance charges.

I can call all extensions no problem.

If I set a PBX code - my extension dialing stops working.

If I call anything other then an extension - I get a busy tone.

If I call the DISA and then try to call out - I get a busy tone.


If I follow these instructions - I get a busy tone - I'm not understanding...


Instructions below:
The PBX sends TIE line calls to the trunks of another PBX through the TIE lines.
a) Trunk Call through Other PBXs—by Making a TIE Line Call Method
[Example]
<Extension Number Method (Access without PBX Code)>
Explanation:
1. Extension 1011 of PBX-1 dials the Trunk Group Access number of PBX-1 "8", trunk group
number "02" (TRG2), Idle Line Access number of PBX-2 "9", and telephone number "211-
4567".
→ 2.8.9 [2-6-1] Numbering Plan—Main—Features—Trunk Group Access
2. PBX-1 sends the call to PBX-2 through the trunk group (TRG) 2 (TIE line).
3. PBX-2 sends the call to the outside party "211-4567".

i have no outside lines in one PBX #3, i want to take a tie line in PBX #2.

 

[rezatafreshi]

Hi. what You Used of The PBX Code Method
but no problem . you can insert in hunt pattern in pbx2 9 and in Pbx 3 remove 9 from features and add in other Pbx
and add in DN2IP
If You Can not Do It I will be glad I do it for you.