Recording 911 calls to history file

[jacabuk]

I need some help programming ESA in load 24. i would like to show it activated on a tty port as well as show the information to the 2250 console. cs1000 rls 6. the end user dials 9911 and pri trunks show 10 digit main number

I am not sure what to enter for the following prompts;

ent 0
ddgt?
dfcl?
esdn?
osdn?

thanks for the help

 

[Reusser]

1st off - you can not notify a 2250 console - only a digital or IP phone where key 0 is only appearance

2nd - as soon as ESA is built, any calls to 911 are logged to any TTY or HST file with MTC

TYPE ESA Type of data block = ESA (Emergency Services Access)
CUST xx Customer number associated with this data block
ENTR xx
- -ESDN xxxx Emergency Services Directory Number - (911)
- -ESRT 0-511 Emergency Services Access route number - (skip this if you would rather use RLI - recommended)
- -RLI xxx Route List Index number - ( RLI previously defined)
- -DDGT x..x Directing digits - (911)
- -DFCL x..x Default ESA Calling Number - (Primary number)
- -OSDN x..x On-Site Notification station DN - (number on key 0 of phone with OSN key defined)


When you test - be sure not to hang up but tell 911 operator you are doing a test. You may also ask if address and number are correct. Unless you have an 911 ALI agreement with your telco provider, number and address are provided by your telco provider.

 

[jacabuk]

Thanks,

i will try this and see what happens