Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Reading the registry in dos?
- Thread starter asm80
- Start date
adholioshake
Programmer
- Feb 9, 2003
- 136
Quite difficultly...
The registry consists of a number of files. It used to be just 'user.dat' and 'system.dat' (found in the Windows directory). For recent versions of Windows, these files are found in the config subfolder of system32 (in windows directory). You cannot change these files directly in windows. From DOS, it might be possible to change them, but it depends what version of Windows you have. If you have a Windows NT machine (anything above 95), then DOS is probably booted from a different partition, and it will not recognize the NTFS. If that is the case though, try and get a hold of the NT Repair Disk, as I think this has a makeshift registry editor. However, this is a system disk, so unless you boot from it, the executable will not work.
Hope that was informative...
Adonai
The registry consists of a number of files. It used to be just 'user.dat' and 'system.dat' (found in the Windows directory). For recent versions of Windows, these files are found in the config subfolder of system32 (in windows directory). You cannot change these files directly in windows. From DOS, it might be possible to change them, but it depends what version of Windows you have. If you have a Windows NT machine (anything above 95), then DOS is probably booted from a different partition, and it will not recognize the NTFS. If that is the case though, try and get a hold of the NT Repair Disk, as I think this has a makeshift registry editor. However, this is a system disk, so unless you boot from it, the executable will not work.
Hope that was informative...
Adonai
There are tools out there (NTFSDOS comes to mind) that will let you modify an ntfs partition from dos, but they may be read-only... not sure. At any rate, you'll need to find the registry files which (as adholioshake mentioned) are different for different versions of windows. If you can boot to dos, have access to the ntfs volumes (using a 3rd party tool most likely), and know which files to modify you should be golden. Look for user.dat, system.dat, and backups are usually named things like user.1st and system.1st. Make sure to use dir -a when you're looking for them, because they have "hidden" and "system" attributes.
--------
It is an honor to recieve an honest reply. (Prov 24:26)
--------
It is an honor to recieve an honest reply. (Prov 24:26)
- Status
Similar threads