RE: Option 11c to Cisco Router Config

[Hybridphoneguy]

Does anyone have a programming example of a option 11c to a Cisco router configuration. Im looking for the Nortel Side of the solution only.


Thanks,

 

[janchundia]

what type of interface cards do you have into the Cisco and Meridian 1 option 11C

 

[Hybridphoneguy]

I have a PRI/DTI on my option 11c and I have a 3620 cisco router with WIC t-1 w/ NM-HDV. I have my dial peers configed on the 3620. I was just looking for the Loads to build on the option 11c.

My goal for this session is to communicate with single line phones at both ends. On the cisco side I have a FXS blade with a analog dial peer built.

On the option 11c side, I'm using a Analog message wait card.

Thanks,