I'm a Newby, Please forgive any Ignorance on my Part;
and thanks for any assistance you may offer.
After running the setup on a Cisco 3550-48 Switch, I get the following:
"Vlan1 is up, line protocol is down"
How do I bring line protocol up?
This is my config file:
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname WET-3548-1
!
enable secret
enable password
!
ip subnet-zero
!
!
spanning-tree mode pvst
spanning-tree extend system-id
!
!
!
!
interface FastEthernet0/1
switchport mode dynamic desirable
!
interface FastEthernet0/2
switchport mode dynamic desirable
!
!
!
!
!
!
!
interface FastEthernet0/48
switchport mode dynamic desirable
!
interface GigabitEthernet0/1
no switchport
no ip address
!
interface GigabitEthernet0/2
switchport mode dynamic desirable
!
interface Vlan1
ip address 10.156.138.16 255.255.255.128
no ip route-cache
!
ip classless
ip http server
!
!
line con 0
line vty 0 4
password
login
line vty 5 15
password
Login
!
!
end
and thanks for any assistance you may offer.
After running the setup on a Cisco 3550-48 Switch, I get the following:
"Vlan1 is up, line protocol is down"
How do I bring line protocol up?
This is my config file:
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname WET-3548-1
!
enable secret
enable password
!
ip subnet-zero
!
!
spanning-tree mode pvst
spanning-tree extend system-id
!
!
!
!
interface FastEthernet0/1
switchport mode dynamic desirable
!
interface FastEthernet0/2
switchport mode dynamic desirable
!
!
!
!
!
!
!
interface FastEthernet0/48
switchport mode dynamic desirable
!
interface GigabitEthernet0/1
no switchport
no ip address
!
interface GigabitEthernet0/2
switchport mode dynamic desirable
!
interface Vlan1
ip address 10.156.138.16 255.255.255.128
no ip route-cache
!
ip classless
ip http server
!
!
line con 0
line vty 0 4
password
login
line vty 5 15
password
Login
!
!
end