Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
"re-boot" at TN
- Thread starter corpmd110
- Start date
LD 20, 10 or 32 it doesnt matter so much now.
In earlier releases of software it was important to du everything in the right Load.
Now they are more flexible.
(this is for option11, for 51 to 81 the tn is four positions)
DISU c u (disable unit c=card u=unit)
ENLU c u (enable unit)
DISC c (Disable card c=card)
ENLC c (Enable card)
In earlier releases of software it was important to du everything in the right Load.
Now they are more flexible.
(this is for option11, for 51 to 81 the tn is four positions)
DISU c u (disable unit c=card u=unit)
ENLU c u (enable unit)
DISC c (Disable card c=card)
ENLC c (Enable card)
Did you take them out a day before you put them back in?
The M1 does a midnight routine and can disable TN's with no phone connected to them...
If you want more info, just ask...
Marc D.
No trees were killed in the sending of this message. However a large number of electrons were terribly inconvenienced.
The M1 does a midnight routine and can disable TN's with no phone connected to them...
If you want more info, just ask...
Marc D.
No trees were killed in the sending of this message. However a large number of electrons were terribly inconvenienced.
- Thread starter
- #4
yes , they were taken out a day before they where put in. I think the software level is old, unsure what it is.
After popping the front off the Meridian I can see that the cards have gone disabled.... Red LED on all cards concerned.
Having problems entering DISU ENLU commands, I sense this PBX is very old in software level.
After popping the front off the Meridian I can see that the cards have gone disabled.... Red LED on all cards concerned.
Having problems entering DISU ENLU commands, I sense this PBX is very old in software level.
Even if you have RLS26 (Will be out in October) the sets will disable over night if you have ovl30 in your midnight routine.
You can check what ovl's the switch runs in the midnight route by printing the OVLY in OVL22
[tt]REQ: PRT
TYPE: OVLY[/tt]
At the DROL prompt you will see which ovl's are run.
To remove a ovl from the midnight route go to ovl17 and enter to the DROL prompt, enter "X" and the ovl you want to remove, or type the ovl number of the ovl you want to add...
Try ENLC and DISC to enable and disable the complete card...
Marc D.
No trees were killed in the sending of this message. However a large number of electrons were terribly inconvenienced.
You can check what ovl's the switch runs in the midnight route by printing the OVLY in OVL22
[tt]REQ: PRT
TYPE: OVLY[/tt]
At the DROL prompt you will see which ovl's are run.
To remove a ovl from the midnight route go to ovl17 and enter to the DROL prompt, enter "X" and the ovl you want to remove, or type the ovl number of the ovl you want to add...
Try ENLC and DISC to enable and disable the complete card...
Marc D.
No trees were killed in the sending of this message. However a large number of electrons were terribly inconvenienced.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question