Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

"No Current Record" Msg Box

Status
Not open for further replies.

Bronte1226

Technical User
Oct 18, 2002
123
US
I have a form with tabs and sub reports. On one particular sub report when tabbing from the prevous tab to the next tab's got focus field, a msg box appears with "No Current Record" as the message. After you hit OK it disappears and allows data entry again. I have tried going through the code for the tab on the previous form field and the new sub report's load commands, and cannot seem to find where this message is being generated from. At one time I had a macro running on the "ON Current" event for the new focus field on this tab. I deleted the selection to run this and even went into the code and deleted it from there as well. I still get the message. Any ideas?
 
set a break and debug. then step thru until you see the message appear. It may not be code but normal behavior. It will show you which step is the last one before it happens, then you can figure out how to stop it.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top