Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

"Error allocating memory for font handling.15"

Status
Not open for further replies.

imjeeper

Technical User
Aug 31, 2002
1
US
When booting up WP7 and when entering the "Print" command, I get the annoying message shown is Subject above. I have to close the messages before proceeding. I don't know how this crept back in having had it once before and finally finding out how to avoid it...but lost the solution. Any one know how I get rid of it?
 
I have the same problem. I see no reponse was posted and that your message is almost 2-1/2 months old. Did you find an answer? I've used Corel Wordperfect 7 since it came out in '95 and never had this problem. Most recently I installed some Kodak picture software that came with the camera and every machine I put it on now has this error message. Would appreciate any ideas on how to correct it. (I have about 350 fonts in Win98SE which should handle approximately 1000, so I don't think that's the issue.)

Thanks, Mike at mczaiko@ix.netcom.com 11-10-02
 
I've had the same problem for some time. I've observed also that a) I've been unable to fully remove WP from my computer - it gets hung up about 3/4th through the process and aborts, and b) I'm unable to reinstall WP over the existing program, with about the same result.

No help from Doink at donedits@att.com 120502
 
When printing in Wordperfect 10 the computer hangs as if it runs out of system resources(buffers memory or something). Nothing responds minimizing does not work etc. After waiting sometimes up to 5 minutes all commands done since it hung up will exexcute at once. All service packs have been updated. I also upgraded from win98 to millinium. This has been going on since July when I upgraded to P4 1.6ghz 384MB memory. Desperately needing help. Law firm who prints a lot of documents.
 
I've recently encountered this problem twice, on two different computers. I have found a Corel patch at which has corrected the problem. Interestingly the the symptoms described on the aforementioned web page do not exist on either of the two computers in question, but the patch worked in both cases. Would suggest that you give it a try. It certainly is better than the error message. Be forwarned, the patch is a very large download.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top