Queueing Problems...

[xpto]

Hi there..

I'm doing a research project at the university and i'm stuck with a problem.. any help would be of great importance.

My problem: I have 3 classes of traffic and i want to use the custom queueing mechanism in a serial interface. This represents no problem but one off those classes should be prioritized in terms of the others.

In other words: i need to "join" priority queueing with custom queueing in the same interface: 2 classes of traffic have different bandwiths (say 60% and 40% of the link capacity) and the other traffic class is control traffic and should have priority upon the other two.


Sorry for the long text but if you reached this point and know how to do this..... PLEASE HELP ME !!!!!

TANX.

 

[fynx]

Hi,
Cisco state that you can only use one queueing mechanism per interface. However, that doesn't mean we cant find a solution to your problem.

I'll pursue any ideas and post back here,

Good luck
Phil. If everything is coming your way then you're in the wrong lane.

 

[xpto]

Tanx Phil.. i'm in real trouble... my teacher is putting a lot of pressure on me ...

anybody out there with a brilliant solution please report..

thank you all

 

[xpto]

I'm starting to have a little hope on this...

I read in "IP Quality Of Service" (page 100) from Cisco Press that it is possible to prioritize some of the queues in a custom queueing mechanism if we setup a so called lowest-custom queue. Till now i haven't found how to do that..

Tanx in advance..

 

[xpto]

I solved out my problem..

I use the command "queue-list 2 lowest-custom 2" and the queue 1 gets priority over the other queues..


thank you all for your suport (till now only phil)