RayEdwards
IS-IT--Management
Hello all, new to the forum here!
Got a question. I'm backing up my SQL server on a DLT7000 Firmware version 2561. The tape selections on the left side of the drive have me confused. I want to set the tape to use 35 & Compress. However, I cannot seem to get these settings without using the "Tape Density" option along w/it.
When my backups run, I get aboooot 20,000 bytes less than a usual backup & Veritas 9.1 reports its "Loading Media" in the Job Monitor. This just started happening 2 days ago and I want it to stop. I believe its due to this "Tape Density" setting on the tape drive itself, and its not allowing compression of the data.
I hope this makes sense to someone...LMAO!!
Any Suggestions?
Thanks!
Ray
Got a question. I'm backing up my SQL server on a DLT7000 Firmware version 2561. The tape selections on the left side of the drive have me confused. I want to set the tape to use 35 & Compress. However, I cannot seem to get these settings without using the "Tape Density" option along w/it.
When my backups run, I get aboooot 20,000 bytes less than a usual backup & Veritas 9.1 reports its "Loading Media" in the Job Monitor. This just started happening 2 days ago and I want it to stop. I believe its due to this "Tape Density" setting on the tape drive itself, and its not allowing compression of the data.
I hope this makes sense to someone...LMAO!!
Any Suggestions?
Thanks!
Ray