QSIG connection MD110 (BC12) to BT dealer board 2

[pafi01]

New user queston, Apologies if this has already been covered, but when searching did'nt find anything.
We are looking for details of the cable we should use to make a connection from MD110 TLU76 (QSIG) to BT ITS dealer board which has an RJ45 connection. We are happy to make the cable but need to know whats involved.
Thanks
Paul

 

[Isinor]

Hi,

Pin outs for the TLU-76...

Or you could order this cable... (Note the /6000 or /20000 is cable length in mm)

Regards
Isinor

 

[pafi01]

Hi Isinor,

Maybe I was'nt very clear but we need a cable to connect from the TLU block connection to RJ45 on the dealer board system. I have heard from somewhere else that we need a block to block connection a balun which has bnd to rj45 but I'm a bit sceptical about this. Any information would be useful.

Thanks
Paul

 

[Mpe]

Hi.

Try to use the kabeling that is used between HL950 and MD.
nr: AP-7503-ERCAB-05
Kabeling: 2G-ERCAB-05 RJ45-1/4 Dc

mpe

 

[fouesnant]

Or may be this oneo TSR9010483 QSIG cable between TLU76 and MX-one

 

[pafi01]

Thanks for all your replies, I will have a look at these cables.

Regards
Paul