I have a problem with QSIG Call setup messages from an Option 61C running Succession 4.5 to a system that uses Dialogic DS-1 boards-
The issue is;
In the setup message of a forwarded call, the setup contains the number and name of the forwarding party-
This is a normal event-
However the Dialogic cards firmware will only allow the IE to be up to a certian lenght-
Dialogic is looking to extend this, but I'm looking for a way to disable this info in the PBX while Dialogic comes up with their answer-
I have removed any data fill in RCAP and can post route and D Channel info if requested-
Thank you
The issue is;
In the setup message of a forwarded call, the setup contains the number and name of the forwarding party-
This is a normal event-
However the Dialogic cards firmware will only allow the IE to be up to a certian lenght-
Dialogic is looking to extend this, but I'm looking for a way to disable this info in the PBX while Dialogic comes up with their answer-
I have removed any data fill in RCAP and can post route and D Channel info if requested-
Thank you