QSIG between two Avaya CM 1

[phonetech1]

Hi,
> I have two Avaya PBXs (8500 6.0 and 8300 4.0)connected with a QSIG/PRI
> trunk and I have a problem with how call information is displayed.
> 8500 is peer-master and 8300 is peer-slave.
>
> When I call from 8500 to 8300 only the name of the phone is diplayed, no
> extension. When I call from 8300 to 8500 I get both Name & extension, which
> is what I want.
>
> Any ideas what parameter controls it?
> I tried to compare both trunk groups, they seems to identical, but some
> screens are different because of release differences.
>
> Thanks

 

[stevehaz]

Have you checked that Send Calling Name and Send Calling Number are set to y on the trunk groups at both ends?

 

[phonetech1]

Yes, both pbxs have send calling name and send calling number set to y in their respective trunk groups.

 

[Smovk]

Did you set public or private numbering for your extensions for this trunk (use command change private-numbering ext-digits 8 0 or change public-numbering ext-digits 8 0)?
Set this numbering according to selected format in trunk on page 3.
TRUNK FEATURES
ACA Assignment? n Measured: none Wideband Support? n
Internal Alert? n Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: y Send Calling Number: y
Used for DCS? n Send EMU Visitor CPN? n
Suppress # Outpulsing? n Format: pub-unk
Outgoing Channel ID Encoding: preferred UUI IE Treatment: service-provider

 

[phonetech1]

Thanks, changed number format to un-unk and it works now.