I have a QPC 414 card that is currently configured with a QPC 720 card for a t1 circuit on its first port. There is nothing programmed on the second port of the QPC 414 card. I am planning to replace the QPC 414 card with a NT5D12 Dual port card. What programming changes do I have to perform to make this change?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
QPC 414 to Dual port pri card
- Thread starter WaltNC
- Start date
- Thread starter
- #3
It's been a while and I don't have any programmed like yours anymore. The ddp needs to built as a dlop in 17. The 414 is built as a term loop. It will have to be reprogrammed. So the trunks will have to come out. You said t1 so I assume no dch.
You shouldn't have to change a thing. The NT5D12 acts just like a QPC414 in those regards. It will already be built under the DLOP, the PBX knows no different. All you should have to do is disable the loop, remove the QPC 414 and install the NT5D12 and enable the loop.
- Status
Similar threads
- Locked
- Question
- Locked
- Question