The Extreme XOS Concepts Guide states that Qosprofile QP7 cannot be created on stacked switches, but I have read somewhere, I can't remember where, that both QP7 and QP6 are unavailable when switches are stacked; which is correct plese? We used to use QP7 for IP telephony, but re-configured this to QP5 when we started stacking switches last year. Since then we have also started using QP4 for CCTV. I avoided using QP6 because I wasn't sure about it.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
QoS on Summitstack. 1
- Thread starter sfurley
- Start date
-
1
- #2
tanderson3733
IS-IT--Management
Don't have the notes in front of me but it's a specific release of XOS that freed up QP6 in a stack. I think it was somewhere in 12.2 or 12.3, so hopefully you've kept your code updated and can use QP6.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question