Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Q-SIG on ISDN BRA

Status
Not open for further replies.

francescod

Technical User
Oct 26, 2010
19
IT
Good Morning,

does someone can help me to configure a Q-SIG on a ISDN BRA? The MD110 release is a BC11 SP11.
I already set the Q-SIG like this:

ROCAI:ROU=100,SEL=511010000000001,SIG=111100000030,TRAF=00151515,TRM=5,SERV=3110000001,BCAP=101100;
RODAI:ROU=100,TYPE?SL60,VARI=15400000,VARO=06300000,VARC=00000314;

But when I sent the command

ROEQI:ROU=100,EQU=1-0-30-02,TRU=1-1&&1-2; (1-0-30 is a TLU79 with all individual free)

the PBX shown the message

"NOT ACCEPTED LICENSE IS NOT AVAILABLE"

Thanks in advance
 
Hi,
printout "LIDAP" and take a look to "EXTERNAL-LINE-QSIG" (allowed used)
regards,
Norbert
 
Thanks SNOR,

I have EXTERNAL LINE QSIG Allowed=30 and Used=30, but I would like to configure the QSIG on a BRI, not on PRI.
Have I to change something in parameter SEL or SIG or serv?

Thank again.
 
Hi,
same Q-Sig License is used for BRI and PRI.

One way is to reduce the channels from your PRI (if not all 30 channels are needed) to have 2 free available Licenses for your BRI.
best regards,
Norbert
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top