I recently replaced an AT&T T1 with an MCI PRI circuit (Opt. 11 25.40) and have had lots of framing errors. The circuit has also dropped a couple of times. MCI is telling me to check the protocol on my route to make sure it matches their switch type (which is a DMS500). I've been instructed by my vendor that the interface should be set to NI2 on the route (which it is) but I'm still getting slips. I dont' even see any option in the NTP that matches DMS500. Is there anything else I need to check? I appreciate your assistance.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
protocol settings for new PRI circuit
- Thread starter coniglio
- Start date
- Thread starter
- #3
- Thread starter
- #4
i know you can put a pri in any 1st cab slot but i have had problems making them stay up in any slot left of a station or cot card.. nortel says that that is not the case but i've moved them and never had to go back... have your tried disl msdl or tmdi and doing a reload? (load 96) ??? might be all you need
john poole
bellsouth business
columbia,sc
john poole
bellsouth business
columbia,sc
- Thread starter
- #6
- Status
Similar threads
- Locked
- Question
