Hi there
I am in the process of installing the xdebug module on my Linux server.
Unfortunately I'm am very un-experienced with the "make" command (and Linux in general) and having followed the following steps without any problems:
I completely have hit a brick wall with this instruction:
I've had a search around the internet for a description of using "make" that doesn't confuse me, and so far they've all made my eyeballs bleed. I also looked at "info make" on my server - but again found this far too confusing.
Hopefully there's a simple answer to this:
What command do I need to enter to "make" my xdebug module.
Thank you in advance
Tama
I do my sums on fingers and thumbs.
I am in the process of installing the xdebug module on my Linux server.
Unfortunately I'm am very un-experienced with the "make" command (and Linux in general) and having followed the following steps without any problems:
Code:
1. Unpack the tarball: tar -xzf xdebug-1.x.x.tgz. Note that you do not need to unpack the tarball inside the PHP source code tree. Xdebug is compiled separately, all by itself, as stated above.
2. cd xdebug-1.x.x
3. Run phpize: phpize
(or /path/to/phpize if phpize is not in your path).
4. ./configure --enable-xdebug (or: ../configure--enable-xdebug--with-php-config=/path/to/php-config if php-config is not in your path)
Code:
5. Compile the module with "make"
I've had a search around the internet for a description of using "make" that doesn't confuse me, and so far they've all made my eyeballs bleed. I also looked at "info make" on my server - but again found this far too confusing.
Hopefully there's a simple answer to this:
What command do I need to enter to "make" my xdebug module.
Thank you in advance
Tama
I do my sums on fingers and thumbs.