Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Proper Configuration with MCDN keycodes

Status
Not open for further replies.

SysTool

Technical User
Jan 25, 2009
35
US
I have the 3 switches linked via point to point T1's passing calls and transfering fine however I do not get the calling party's name only the extension #.

MICS 1 = NVRAM 2.0, DR7.0, SL-1 (slave), clocking = primary
MICS 2 = NVRAM 2.0, DR6.1, 1st T1 - SL-1 (Master), clocking = Primary
MICS 2 = 2nd T1 - SL-1 (Master), Clocking = TimeMaster
MICS 3 = NVRAM 1.0, DR7.0, SL-1 (slave), clocking = primary

I do not have a T1 to the LEC on any switch so I am using one of the T1's in the 2nd switch as "TimeMaster".

I am wondering if the NVRAM and or software Rev needs update and also should I set up the T1's to be:
Master to Slave - Master to Slave.

Any advise would be appreciated. Thank you.




 
I hope you PRI's and not T1's.

Configure the Business Name for each of the MICS and give it a shot.
Make sure that you disable Send Name for any PRI's you may have going to the C.O. and enable it for the point to points.

-SD-
 
Yes PRI's. No PRI's to CO off any switch. I'll try to config business name and let you know. Thank You.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top