Hi guys,
I was given a PL1600 with two 9.1 GB ultra3 scsi. The problem was that it crashed and when rebooted went into a cycle of rebooting over and over again.
I am not a systems guy (its a very small company) but here is what I did.
I booted with a smartstart cd and ran System erase utility. After that I rebooted from the cd and was in the process of doing an assisted installation when the system froze up on me. After that the server does not boot from cd or floppy or anything. I power it on and it just stays like that. THe light flashes once on the hard drive - a red error light and thats it..
Can you please help..Thanks a ton in advance.
I was given a PL1600 with two 9.1 GB ultra3 scsi. The problem was that it crashed and when rebooted went into a cycle of rebooting over and over again.
I am not a systems guy (its a very small company) but here is what I did.
I booted with a smartstart cd and ran System erase utility. After that I rebooted from the cd and was in the process of doing an assisted installation when the system froze up on me. After that the server does not boot from cd or floppy or anything. I power it on and it just stays like that. THe light flashes once on the hard drive - a red error light and thats it..
Can you please help..Thanks a ton in advance.