Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Programming the actual IP phone in 7.0

Status
Not open for further replies.

poopus

Technical User
Jan 18, 2007
50
US
Recently, we upgraded our system to 7.0 After the upgrade, when trying to reset the phone features in an existing phone, the phone asked for a pass code. I found the default pass code. (26567*738). That worked okay but it only takes me through the options associated with our data network. I have not been able to get in to the actual phone options to reset a TN. The phones in this case were a 1230 and a 1220. Any help would be greatly appreciated.

cwk

 
In order to reset the node/TN, you have two options:
1. reboot the phone and change them when the node/TN are displayed. The ability to change at that time is controlled by the installer password.
2. use the "zero-touch" approach and use tftp/http files to feed the node/TN to the phone based upon it's mac address.
 
I guess I was not quite clear enough. I actually can change the TN. I can't get to any other set up features such as speed, duplex settings, IP and Vlan , etc.

cwk
 
You can change to all manual at configuration interface. You many need to change it to auto first then to all manual.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top