I HAVE A BOGEN PCM200C PAGING SYSTEM THAT WAS OPERATING ON A OPT11C PROGRAMMED AS A WATS TRUNK AND WORKED FINE, THEY UPGRADED THIER SYSTEM TO CS1000E 5.0 AND WHEN YOU ACCESS THE PAGE PORT IT BEEPS TWICE FROM THE PAGING SYSTEM AS NORMAL BUT WHEN YOU DIAL ANY OTHER DIGITS AFTER THE BEEP THE TRUNK DROPS AND YOU GET A FAST BUSY. ANY SUGESTIONS?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations dencom on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
PROGRAMMING OF PCM200C PAGING SYTEM ON CS1000E 5.0
- Thread starter coameno
- Start date
ANY SUGESTIONS? "
Sure, find the caps lock key on your keyboard. Press it. Then retype your query here.
ACSS-SME
fo shizzle ma nizzle.
Sure, find the caps lock key on your keyboard. Press it. Then retype your query here.
ACSS-SME
fo shizzle ma nizzle.
- Thread starter
- #3
Sorry, it was 3AM, I have a Bogen PCM200C paging system that was operating on an OPT11c Programmed as WATS trunks and worked fine. They upgraded thier system to a CS1000E 5.0 and when you acess the paging port it beeps twice from the pagging system to aleart you to enter the Zone, but if you enter any digits after that it disconnects and I get a fast busy.
- Thread starter
- #5
hairlessupportmonkey
IS-IT--Management
is it? damn - I thought I have been answering splicecom questions all this time!
ACSS - SME
ACSS - SME
- Status