Currently I have 4 interfaces on the PBX to make calls to mobile. Any connection to any wireless carrier connection goes through these interfaces, which I would like to improve, to create a form where I can say, if the link is for the mobile operator, the call should go through the interface A, the link is to a number of cellular carrier B to B connection goes out the interface and so on, it is possible in Hipath 3800?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Programming Inteigente
- Thread starter teclesoft
- Start date
obtsystems
Programmer
It can be done using lcr on the system
You will have to know how to set this up properly or it could block calls getting out at all
You will have to know how to set this up properly or it could block calls getting out at all
- Thread starter
- #3
- Thread starter
- #5
- Status
Similar threads
