Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Programming DTR 32D Message key (DTerm Series i): 1
- Thread starter boomer64
- Start date
-
1
- #2
OzzieGeorge
Programmer
gmannatl
That would only work if it was set up as a speed dial key and if it was set up that way it wouldn't be a message key!
Command 5115
"Destination of the call from the station to which Message Waiting has been set"
Is I believe what you are looking for!
That would only work if it was set up as a speed dial key and if it was set up that way it wouldn't be a message key!
Command 5115
"Destination of the call from the station to which Message Waiting has been set"
Is I believe what you are looking for!
- Thread starter
- #4
Thanks gmannatl that did the trick it worked just as you said it would.
OzzieGeorge I guess it was programmed as a speed dial key it is labeled "message" as all of the other phones in the system are. I will keep CMD 5115 in mind for the next time though.
Ron
OzzieGeorge I guess it was programmed as a speed dial key it is labeled "message" as all of the other phones in the system are. I will keep CMD 5115 in mind for the next time though.
Ron
- Status
Similar threads
