Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Programming DISA
- Thread starter pelleg
- Start date
TouchToneTommy
Vendor
Renumber the Remote Access Code (890) to the DID number. Set up a barrier code for Remote Programming.
- Thread starter
- #3
TouchToneTommy
Vendor
Sorry if that was too obtuse 
Go to Renumber - Single - Remote Access - (The current Remote Access number is shown - Default is 889 [and I had the wrong number in my previous answer]) - Use Backspace to remove it - dial the DID number you want to assign to Remote Access - Enter
Now go to Lines and Trunks - Remote Access - Barrier Codes - Code Info - Code Entry - Dial Code ID - Enter - Drop to Erase - Dial New Code - Enter
Go to Renumber - Single - Remote Access - (The current Remote Access number is shown - Default is 889 [and I had the wrong number in my previous answer]) - Use Backspace to remove it - dial the DID number you want to assign to Remote Access - Enter
Now go to Lines and Trunks - Remote Access - Barrier Codes - Code Info - Code Entry - Dial Code ID - Enter - Drop to Erase - Dial New Code - Enter
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question