Programming DISA on Prologix v6.3

[option11]

I'm new to Definity Prologix programming and was wondering if someone can give me some help or advice on programming a single CO line for DISA.

On the Nortel switches it is called DISA, but I can't seem to find that term anywhere in my administration manual. Could someone tell me what they call it on the Definity?

Do you require a special TN card or software upgrade/option for DISA access? Any help is greatly appreciated. Jim

 

[wshiou]

" remote access "
you can type "ch rem" to enter a unassigned ext & barrier code ,authorization code , cor ,cos ,date......then put the extension to incoming destination on CO trunk group

 

[option11]

Thanks wshiou, but under change I don't have a "remote access" option. Any suggestions? Jim

 

[wshiou]

Dear Jim :
I think your login was disallowed to change remote access.
(if "display permissions xxx", the Administer Trunks is N).