Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Programming ANI 1

Status
Not open for further replies.

sadieselbow

Technical User
Aug 17, 2010
11
US
Hi there, I am new to definity and taking care of PBX. I need to know where to go or how to create ANI using the PBX. I may be mistating my request, but hopefully someone gets the gist.

Thanks

 
Enter CHA FEAT (CHANGE FEATURE ACCESS CODE) and near the bottom of page 3 you should see "Self Station Display Activation". Enter a unique three-digit code such as 616 then press Enter or F3. Test by going to phone that has a display and enter the code you created. Hope this helps.
 
If you are trying to administer the number that is sent when you make an outbound call, assuming you are using ISDN trunks, you would either use 'change public-unknown' or 'change isdn public-unknown'. The command varies with software load.

Kevin
 
Thanks for the post. I did misstate my question, but you were smart enough to understand what I was looking for.
I was looking how to program the service for verifying the number I am on.

Another question, is how to make the system perform a call back verification.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top