Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Programming a Valcom 6 zone paging system on a Meridian Option 11 Switch 1

Status
Not open for further replies.

ronshaw

Technical User
Apr 18, 2012
16
US
I am looking for step by step instructions and load commands necessary to program a Valcom 6 zone paging system on a Meridian Option 11 Switch.
 
Is it a Trunk or Station interface? What type of line does the Valcom need from the PBX?

~~
Gene at GHTROUT.com
 
it is a trunk line. I have a tn that is coming from the switch. I have tried to LD 10, LD 14, and LD 16. I do not know all the steps to take on each LD commands
 
1: Identify an Access code for paging. LD16 Program a Trunk route, TKTP=WAT, ACOD (Your code); MANO=YES. Everything else default.
2: LD14 Program a trunk. TYPE WAT, Route from above, Member 1, CLS=DTN; Everything else default.
3: Cross connect trunk to paging input

To test, dial access code, then zone number.

~~
Gene at GHTROUT.com
 
I am still having problem with each ld command, do you have a print out of each load command
 
I gave you the programming for a working 6 zone valcom in the other thread you started. If you build it exactly like that it will work.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top