Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Program a 3904 to go right to voice mail with no rings

Status
Not open for further replies.

BStephens

MIS
Jun 20, 2005
35
US
What setting do I have to change to make a 3904 not ring but just go to voice mail? I do not have a physical phone set up so that I can make is busy.
 
Without a phone I would just use an ACD dn pointed to VM.
 
If the 3904 is not a physical port then out it and build a phantom 500 line with that DN and
FTR DCFW to the voicemail pilot number.

If the 3904 is a physical set then just add a CFW key. Then physically call forward it to voivemail.
 
Thanks for the responses. What I have is a 3904 programmed on a TN but no phone attached. I have a primary DN and 3 roll over DN's. If I set up a 500 set I wouldn't need the rollover lines would I?
 
Do what HAWKS said. Out the 3904 and build an ACD using the DN that was on the 3904. MAXP = 1, NCFW = VM Pilot Number




 
Ld 23
Req : new
type acd
....



Meridian, Callpilot, CCM (Symposium) from Germany
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top