Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Problems with grip points

Status
Not open for further replies.

militantmandy

Technical User
Dec 20, 2006
17
GB
This is probably something really simple, but suddenly in Illustator, when i use the direct selection tool i can no longer see anchors on lines. I have the guides on and it comes up with the word "anchor" but I can't see it!! Also, on a cuve, i can no longer see the little grips that allow you to change the curve shape.

I'm sure this will be a piece of cake for you folks!
 
Tried 'CTRL + H' yet?

-E

(DISCLAIMER: Self-taught AI user; unorthodox methods w/good results)
'There is no LEASH LAW for the IMAGINATION!'
myspace.com/erixworx
 
I find that useful for when there's a lot of overlapping shapes and the outlines are making visibility poor. Of if there's just one shape and you're adjusting it and keep checking to see how it looks, and don't want to adjust, deselect/check, select again, adjust, deselect/check, select again, adjust, deselect/check, select again, adjust, deselect/check, select again,...
-E

(DISCLAIMER: Self-taught AI user; unorthodox methods w/good results)
'There is no LEASH LAW for the IMAGINATION!'
myspace.com/erixworx
 
I can see how that would be usefull. Just one of the many commands i've not come accross yet. Thanks again!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top