Problems setting ESA_APND to NO

[gsdelong]

I have a single entry for CLID and I am unable to use load 15 to change ESA_APDN to NO

after typing 0 on entry t steps through the values until it gets tot ESA_APDN and then just allready has a yes and goes to the next line.

Do I need to change something else first.

I am trying to have all extensions if they have a DID or Not send out the main number defined in clid.

Right now if it does nto have a DID number it works as expected but send out jibberish if the DN has a DID number.

 

[Firebird Scrambler]

You might have to delete the CLID entry and rebuild it again as shown below in this old report I found.

Patch 12334 allows a CLID entry to be removed in LD 15 instead of getting BUG 481.

Problem:
CLID Entry Table 2 could not be removed from system by performing a service change.The entry was not removed and the Data which remained was corrupted.
HARDWARE and DATA SETUP:
Option 81C 1911 (CP2) running release 24.25
The following was the CLID entry that was attempted to be removed.

REQ: PRT TYPE: CLID CUST 0 SIZE 256
RNGE INTL ENTRY 2 HNTN 403 ESA_HLCL 232
ESA_INHN NO ESA_APDN YES HLCL 232 DIDN YES
HLOC 765 LSC CLASS_FMT DN
ACTIONS:
1- Load overlay 15 and X CLID entry 2 REQ: CHG
TYPE: TYPE NET_DATA CUST 0 OPT AC2 FNP CLID
YES SIZE INTL ENTRY X2 ENTRY 2 DELETED!

BUG481 BUG481 + 046EEF60 046F88E2 0499BF60 04999B24 04998BA2
BUG481 + 04980286 058B34F4 058B2614 048B2E14 048B1CBE
BUG481 + 048B156E 048AFADC 048AC946 04AE58A6 04AE5008
BUG481 + 04AE4BC4 ENTRY ISDN

Note: The BUG481 was not generated when this problem was duplicated in the BVW lab with Lab data, but we did experience the corruption.

EXPECTED Results:
That the CLID Entry Table 2 would be removed.
ACTUAL Results:
CLID Entry Table 2 was not removed and the Digits in the table changed to the following.
ENTRY 2 HNTN ESA_HLCL 8 ESA_INHN YES ESA_APDN NO HLCL 358
DIDN SRCH HLOC LSC CLASS_FMT NTN

Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website =

http://somertel.com

linkedin

 

[gsdelong]

Ok maybe I misunderstood but I tried creating a new entry

I have the same issue it automatically populates the ESA_APND value as yes with no ability to change it.